Hi
I am using a Virtual Server 2012 and i am runing exchange 2013(RTM),
I have followed the prerequisite on the technet and have gone to send a email on the OWA and it goes to the drafts folder (even if i send an internal email)
I then change a few setting like the send connector and tried again but it still failed,
I rebuilt the server thinking it was a bad install,
and the same thing happed again?!?!?!
This time i also installed office on a laptop and tried sending an email, it went to the sent mail
but when i check the email account no message turned up
I tried sending an internal message and it failed again.
i can receive emails.
The router/firewall is correct as i had a virtual server 2008R2 and exchange 2010,
Please Help
Jay
I am using a Virtual Server 2012 and i am runing exchange 2013(RTM),
I have followed the prerequisite on the technet and have gone to send a email on the OWA and it goes to the drafts folder (even if i send an internal email)
I then change a few setting like the send connector and tried again but it still failed,
I rebuilt the server thinking it was a bad install,
and the same thing happed again?!?!?!
This time i also installed office on a laptop and tried sending an email, it went to the sent mail
but when i check the email account no message turned up
I tried sending an internal message and it failed again.
i can receive emails.
The router/firewall is correct as i had a virtual server 2008R2 and exchange 2010,
Please Help
Jay